Skip navigation
Skip Navigation LinksDPH Home > DEHS Home > FAQs > Public Swimming Places FAQs

Public Swimming Places FAQs

1.  I just noticed that a pool that I swim in was closed. Should I be concerned?

Public pools are posted closed by Environmental Health as a preventative measure when significant health or safety violations are observed during an inspection. Most closures are because of very low or very high chlorine levels, very cloudy water, or safety items like missing main drain covers. Actual bacterial samples of the pool water are rarely taken.

Top of page

2.  What kind of pool test kit do I need for my public pool?

At the minimum, you need a test kit that can accurately check pH and “free chlorine” in the pool water. To accurately check “free chlorine”, the test kit should use DPD tablets or liquid. “OTO” (yellow liquid) type chlorine test kits are difficult to use to accurately determine free chlorine. The test kit must be able to test for free chlorine from 0.5 to 3 ppm (parts per million). However, it is suggested that test kits with a higher free chlorine range (to 5 or 10 ppm) be used. If pool stabilizer is used, cyanuric acid must also be checked, at least once per month. Cyanuric acid test kits are available but you can also take a water sample into some pool supply companies once per month. Most test kits will also check for combined chlorine, total alkalinity, and calcium hardness, which are useful for properly maintaining a pool.

Top of page

3.  What kind of records must I maintain for a public pool?

You must maintain daily test records for pH and free chlorine. In addition you need to include in your records any maintenance performed and monthly cyanuric acid checks (if pool stabilizer is used).

Top of page

4.  Do I need to notify the Health Department if I change pool equipment?

Generally speaking, if pool equipment is replaced with the same make and model number (like for like), there is no need to notify the Health Department. Otherwise, contact the health department, plan check section, for approval prior to any equipment installation/replacement. New pumps must be able to maintain the same turnover rate. Filters must be properly sized for the system. Chlorinators must be sized properly to ensure adequate disinfection.

Top of page

5.  Does my public pool have to be maintained by a Certified Pool Operator?

Not at this time, but it is highly recommended. Properly maintaining a public pool requires proper training. Basic pool training is best acquired in a Certified Pool Operator class.

Top of page

6.  What should I do after a fecal accident in a public swimming pool?

7.  Why does my pool/spa need to be chlorinated?

Pools should be disinfected continuously by a chemical which imparts a residual effect. Chlorine is a type of "disinfectant", also called a "sanitizer". Disinfectants or sanitizers destroy living microorganisms and bacteria, preventing the transmission of disease. There are several types of disinfectants, such as chlorine, bromine, ozone and UV light. Public pools need a disinfectant with a measurable residual.

Top of page

8.  How much chlorine should I have in my pool and spa?

It is important to have the correct concentration of free available chlorine in the water at all times when the pool or spa is available for use. Unlike combined chlorine, free available chlorine is efficient at destroying the majority of harmful microorganisms. A minimum of 1.0 ppm free available chlorine is required if cyanuric acid is not used as a conditioner. Otherwise, a minimum free chlorine residual of 1.5 ppm is required. The maximum concentration of free available chlorine must not exceed 10 ppm while the pool is available for use. Chlorine must be dispensed through a properly-sized automatic chlorinator to ensure consistent levels of chlorine.

Top of page

9.  Why can I smell chlorine in the pool and patrons complain of burning eyes but my test kit indicates there is no free available chlorine?

It is likely that the chlorine has combined with organic matter in the pool and has formed chloramines. Chloramines have a chlorine-like smell and can cause eye and skin irritation. Use a test kit to determine the amount of combined chlorine. The combined chlorine level should not exceed 0.4 ppm. Adding the appropriate amount of addition free available chlorine will help to eliminate chloramines.

Top of page

10.  What is cyanuric acid?

Cyanuric acid is an acid that is marketed as a chlorine "stabilizer" for swimming pools. It is also referred to as a "conditioner." When exposed to the ultraviolet rays of the sun, the free chlorine in the pool water will break down and escape. Cyanuric acid is intended to reduce this loss of chlorine. Cyanuric acid is often a component of chlorine tablets used in automatic chlorinators. It is also available in powder form. Cyanuric acid residual remains in the water and will increase in concentration as additional amounts of cyanuric acid are added to the water. At high concentrations (>50 ppm), cyanuric acid can substantially decrease the effectiveness of chlorine.

Top of page

11.  What chemicals do I need to test for regularly?

Chlorine (or other approved disinfectant) and pH levels should be checked and recorded on a maintenance log at least once per day. Cyanuric acid levels should be checked and recorded at least once per month. Other chemical tests (such as alkalinity, calcium hardness, and total dissolved solids) should be checked regularly to maintain proper water balance.

Chemical Requirements
  minimum
amount
desired
amount
maximum
amount
when to check
and record
Free chlorine without
"stabilizer"
1.0 ppm 1.5 ppm 10 ppm Daily
Free chlorine with
"stabilizer"
1.5 ppm 1.5 - 3.0 ppm 10 ppm Daily
"Stabilizer" (i.e.,
Cyanuric Acid)
0 ppm Up to 50 ppm 100 ppm Monthly
pH 7.2 7.4 - 7.6 8.0 Daily

Top of page

12.  My pool serviceman comes twice a week and checks the chemical levels. Do I still need to do that?

YES! The law requires all public pools and spas to have an on-site operable test kit, and a daily log of chlorine, pH levels, and other maintenance actions. You should have basic knowledge of pool maintenance and water chemistry balance. If the pool chemistry is not correct on any given day, adjustment must be made as soon as possible to keep the water safe for patrons.

Top of page

13.  When should the pool and/or spa be closed to the public?

The pool/spa should be closed anytime an immediate and imminent health risk exists. These could include the following: excessive water cloudiness (the main drain is not visible); no free residual level of disinfectant/sanitizer (e.g., chlorine); the filtration and/or automatic disinfection system is not operable; the covers over the main drain or the equalizer lines are broken or missing or there is a suction hazard; the underwater light fixture has water in it; chemicals are added to the water and sufficient time has not elapsed for proper mixing; or any time you feel there is a health risk to patrons.

Top of page

14.  Is there a class I could attend to better understand my pool?

Yes - there are several companies that offer a class and exam to become a National Swimming Pool Foundation Certified Pool Operator (CPO). Click here to find a class near you

Top of page





Get Adobe Reader